It has a brilliantly powerful 15 AMP motor, which can deliver 4,800 RPM of cutting power. Is is normally more than enough for most woodworkers and hobbyists. It has stowable anti-kickback pawls and and excellent riving knife and spreader for accurate cuts. This is a great entry level saw at a great price, definitely worth looking at for your next purchase or project.
One of our favorite features, however, would have to be the built-in safety system. The safety system quickly detects when human contact has been made with the blade by reading the electrical signals that are sent throughout the blade and locks down on the cabinet within milliseconds.The whole process only takes about 1/200th of a second and helps to save craftsmen from devastating injuries every day.
The more table size you have, the more support you have which is always a plus, not only for convenience but safety too. There are right side extensions that can be purchased for table saws that increase the table saw’s capacity to get to the center of a 4 x 8 sheet of wood. Although most saws have a rear band that supports the wood as it exits the saw, an additional safety measure is to rig up an outfeed support of some kind in addition to this rear bar. Be sure that the outfeed support you set up is ¼” lower than the table saw is.
Belt drive table saw motors run on a pulley system, most of the time some power is lost through this system, but belt drive blades can cut through thicker timber and hardwoods. They can produce power of around 3 to 5HP and thanks to the motor being mounted further away from the blade with belt drive, the motor will last longer as less dust will get into the motor. One thing to consider though is that belt drive will be in general more expensive and are normally found on heavy cabinet type saws, so this must be considered when working out your budget.
This table saw was completely redesigned and heavily improved in both safety measures and cutting capacity. For safety, DeWalt redesigned the red power switch to be electronic. It automatically resets the saw to turn off if the power is interrupted whatever the cause. I’ve heard some job-site horror stories regarding table saws who weren’t turned off properly so this redesign was very much needed.