The design is among the first ones to vary voltage in alignment to the outfitted tool. Its versatility is unmatched. The battery usage can be easily shared as you customize the operation itself. Because of its lightweight and small nature, users can easily move it from one place to another. It also doesn’t require lots of space, which is why it is perfect for home garages and commercial spaces alike.
The legs fold easily with an intuitive mechanism that feels well thought out, and the safety attachments stow away within the unit, reducing its form factor and allowing it to be tucked away in a corner when not in use. However, the unit does weigh 90 pounds, so if you’re going to be loading it in and out of a truck bed several times a day or needing to haul it up and down the stairs where the wheels can’t help you, you may want to look at a lighter job site saw that dispenses with the stand.
In portable table saw models, the motors are supported by trunnions mounted to the underside of the table. The resulting vibration reduces accuracy. These trunnions are usually made of lightweight steel or aluminum, which are susceptible to wear. And because these saws are small, cutting full-size sheets of plywood or MDF isn't a good idea unless the sheet is supported by a table extension.
What is a fence? How important is it in a table saw? It gives you an option for horizontal or vertical adjustments. A good rip fence should be aligned to the blade at all times. Without a fence, everything will be disgusting. Ensure that it is heavy and that it can glide smoothly across the rails. Also, make sure that the locking mechanism is perfect and convenient.
All these saws have fences that extend to at least 24 in. to allow you to rip a 4 x 8-ft. sheet of plywood in half. And they all have a slightly different way of accomplishing this. DeWalt has the most straightforward method. You just push the fence out on its rails and flip over the board support. On the Rockwell saw, you flip out a hinged fence rail. The only drawback to this fence is that it must remain in the extended position for any cut, so it takes up quite a bit of room. The remaining saws require you to release one or two levers and pull out the fence extension.
When you purchase your table saw, more than likely it will have standard 10” carbide tipped blade that is good for general purpose use. This blade is capable of cross cutting a 4 x 4. If you replace it with a 40 tooth combination blade you will improve the quality of your cuts significantly and more than likely be much happier with the blade overall. You can get specialty blades also if you are going to be cutting other materials as well.
bosch table saw
There’s a lot to like about this saw. The stand is easy to set up and very sturdy. We like the smooth-operating table extension and the blade guard’s hold-up feature and ease of installation. The only downside we found is that the motor mount is less rigid than those on the other saws we tested. We suspect that’s why the cut quality on our torture test was not as good with this saw.
The DeWalt doesn’t go above and beyond here but has some standard safety equipment as part of its Site-Pro Guarding System. The Blade Guard Assembly is a standard clear plastic set of guards that allows the wood to be fed to the blade but shields you from putting hands on the exposed blade in a slip. The guards will lock in a raised position when you need to see the blade—for example, when adjusting the blade height—which lessens the temptation to remove this safety feature when it’s in your way.
We spent a lot of time setting up and taking down the saws to see how well the stands worked and how easy it was to install and remove the blade guard and anti-kickback pawls. Then we ran a torturous ripping test with 3-in.-thick slabs of oak to find the best table saw. And finally, we used the saws for more conventional tasks like cutting plywood and ripping framing lumber as another test to determine the best table saw.