If the piece of wood that you’re cutting does not have a straight edge to run along the fence guide, you won’t get an accurate cut. An uneven edge will move back and forth against the fence guide. A good way to create a straight edge to work with is to fasten the piece that you’re cutting to a piece of plywood that has a straight edge. Using screws or nails, you can attach the uneven wood to the straight piece, so that the straight edge runs along the guide rail. Make sure that the straight-edged wood is narrower than the width of your intended cut so that you only cut the piece that is intended to be cut.
There’s a lot to like about this saw. The stand is easy to set up and very sturdy. We like the smooth-operating table extension and the blade guard’s hold-up feature and ease of installation. The only downside we found is that the motor mount is less rigid than those on the other saws we tested. We suspect that’s why the cut quality on our torture test was not as good with this saw.
The DeWalt DW745 is not their top-of-range job site table saw, but it’s a great competitor among 10” portable table saws. The incredibly reasonable price makes it an attractive option for both woodworking hobbyists and professional carpenters alike. If you find a 10” job site saw any cheaper, take a serious look at whether you’re getting the same quality.

Hybrid table saws were produced by many manufacturers as they found there was a gap in the market for a table saw between the contractor saw and the cabinet saw. Contractors wanted something with the power and functionality of a cabinet saw but not necessarily the heavy weight of a cabinet saw. One good other point for the hybrid saws is price, cabinet saws are often very expensive because of the cast iron table tops etc. so a hybrid is a great saw if you’re looking for something slightly cheaper.

Also designed to deal with the issue of kick-back, ​these type of pawls essentially pin down the cut wood so that it cannot go flying back toward the user. These pawls are mounted above the cutting surface and hang on to the wood through the use of their “claws,” which grab the wood once it has been cut. They prevent it from going anywhere before you’re ready for it to move.
Rockwell diverged from the crowd with this offering. For starters, the riving knife, anti-kickback pawls and blade guard are connected and remove as a unit. If you do remove them to make a non-through cut, you have to install the separate riving knife first. It’s not difficult, just different. This is the only saw with a right-tilting motor. We prefer left-tilting motors because it’s safer to make bevel cuts with the fence on the right side of the blade. There’s no port for attaching a vacuum cleaner, but there’s a large dust bag that does a good job of collecting sawdust. This saw cuts 3-9/16 in. at 90 degrees, 1/16 in. more than the next closest competitors, allowing you to rip a 4×4 in one pass. And like the Ryobi saw, it has a 30-in.-wide rip capacity.

best table saw under 1000


The continuous-read, tape measure–type scale is ingenious and easy to read, and Ridgid’s lifetime warranty covers it against breakage. The Ridgid saw has the most versatile miter gauge with holes and slots for mounting extensions and accessories. The designers have cleverly fashioned the stand to also serve as a left-side outfeed support for ripping plywood.

best table saw 2020

×