If the piece of wood that you’re cutting does not have a straight edge to run along the fence guide, you won’t get an accurate cut. An uneven edge will move back and forth against the fence guide. A good way to create a straight edge to work with is to fasten the piece that you’re cutting to a piece of plywood that has a straight edge. Using screws or nails, you can attach the uneven wood to the straight piece, so that the straight edge runs along the guide rail. Make sure that the straight-edged wood is narrower than the width of your intended cut so that you only cut the piece that is intended to be cut.
Power by a 5 Amp motor with 4,500 RPMs, the Metabo HPT C10RJM Table Saw can cut through wood, hardwood, plywood, and composite wood materials. The Saw features soft start, an electric brake, and a telescoping table extension that can support a max rip capacity of 35″. For increased jobsite performance, the Table Saw Stand feature wheels that allow users to maneuver through tough terrain with ease. Also, the sturdy legs on the fold and roll stand provides extra stability easy set up/breakdown.
The blade is a 24 tooth carbide tipped blade that is durable and long lasting. You can even adjust it to a 45 degree angle for those more difficult bevel cuts. If you’re working on uneven ground, you’ll love the rear feet that are fully adjustable so you can level you work space. You’ll get a lot of use out of the onboard storage that will give you easy access to the push stick and guarding components. Weighing only 45 pounds, you can move the table saw from work site to home with ease.
All these saws have fences that extend to at least 24 in. to allow you to rip a 4 x 8-ft. sheet of plywood in half. And they all have a slightly different way of accomplishing this. DeWalt has the most straightforward method. You just push the fence out on its rails and flip over the board support. On the Rockwell saw, you flip out a hinged fence rail. The only drawback to this fence is that it must remain in the extended position for any cut, so it takes up quite a bit of room. The remaining saws require you to release one or two levers and pull out the fence extension.
Once you’ve gathered your materials, turn your attention to the plate in the middle of the table saw. It surrounds the blade and should have two screws that hold it in place (however some models will have four). Use your screwdriver to undo these screws and set them aside. Then take the plate off and set it to the side as well. Then check to make sure the blade is at its full height by going to the back of your table saw and winding the blade up to full height.
Along with thinking about how the table saw will be used now, it is important to also consider how you will be using it in the future. Will your usage increase or decrease? Many woodworkers may turn a hobby into a fulltime profession if they are talented at what they do. Why are these considerations important? Because they will give you better insight into the kind of money you should spend on your table. If you are going to go into business for yourself in a year or two, spending the money for a high-quality table now is a good idea. It will save you from having to buy another table in the future to accommodate your new needs as a business rather than just a hobbyist.
It’s best to avoid this issue entirely by making sure that there is no material that could catch on any of your work material and jeopardize your health or safety. Now that you’ve got the basics down for how to properly dress for working with your table saw, you’re ready to inspect your equipment. To start with, you’ll want to make sure the table saw is unplugged before examining it and making sure you’re good to go.