Contractor saws weigh quite a bit more than portable saws, averaging between 150 and 350 pounds, but are still somewhat portable. They have a heavier, cast iron table top, and a motor that is usually more powerful than a jobsite saw. Even so, they’re within prices affordable for more committed hobbyists. Contractor saws can range between $800 and $2,000. They’re good for basic cutting tasks, as well as making home furniture and cabinetry work.
With a maximum cut depth of 3.125 inches and a 32.5-inch rip capacity, the 10-inch blade of this DeWalt table saw handled all the relatively light-duty board ripping I needed from it, but I also tested it against a variety of plywood and other board sizes to assess its capability. The 15-amp motor is fairly standard for this contractor or job site level of table saw, and none of the boards I threw at it caused it to bind—good news, as binding is at best annoying and at worst dangerous.
Obviously, given its size, the TruePower 01-0819 isn’t the kind of table saw you’d spring for to take on larger projects that require greater motor power — after all, it’s by no means revolutionary in the torque department. But for those who work with smaller materials or softer wood, the Gino Development TruePower 01-0819 Mini Electric Table Saw is a worthwhile, no-frills buy that’s easy on the wallet and can fit in virtually any space with plenty of room to spare.
Once you’ve made sure that the table saw is unplugged and there aren’t any extra materials in your workspace, you should turn your attention to the miter slot. See also related: Top 10 Miter Saws here. You’ll want to make sure that the miter (click here for sliding miter saws) slot is parallel to the blade. It is important that all measurements are precise and exact – nothing short of parallel will do. Once you’ve measured the blade and the miter slot, you’ll need to check the fencing as well.
This “review” is a giant nothingBurger. There is not one scrap of objective comparison between these saws. Because you sell them, they’re all great and will all zip right through “the hardest woods”. Bulll$hit. You did not test, compare, analyze, or use ANY of these saws. Re-hashinf manufacturer specs is a “Roundup” but it certainly is not a review. Typical sales pablum.
This table saw was completely redesigned and heavily improved in both safety measures and cutting capacity. For safety, DeWalt redesigned the red power switch to be electronic. It automatically resets the saw to turn off if the power is interrupted whatever the cause. I’ve heard some job-site horror stories regarding table saws who weren’t turned off properly so this redesign was very much needed.