The DeWalt doesn’t go above and beyond here but has some standard safety equipment as part of its Site-Pro Guarding System. The Blade Guard Assembly is a standard clear plastic set of guards that allows the wood to be fed to the blade but shields you from putting hands on the exposed blade in a slip. The guards will lock in a raised position when you need to see the blade—for example, when adjusting the blade height—which lessens the temptation to remove this safety feature when it’s in your way.
The built-in rack and pinion fence system, which acts as a guide for boards that runs parallel to the blade, adjusts by hand and is both easy to use and very accurate. I learned to trust the fence and its measurements once I got the saw set up, and it made my workflow faster knowing I didn’t have to measure everything four times to double-check the DeWalt.

A splitter is a piece of metal that keeps the blade from binding in whatever material you are cutting if the saw kerf starts to close up. The splitter is vertical and sits directly behind the blade. This plays a big part in preventing kickback and should be mounted on the motor assembly so it rises and falls with the saw blades movements. You can also get splitters that can be adjusted to fit the width of the kerf.

10 inch table saw blade


The latest DeWalt Table Saw is a compact 10-inch job site power saw with a number of great features. First of all, it has a rack and pinion telescoping fence which will let you make fence adjustments easily. This saw has a 24-inch rip capacity so you can use this for a variety of materials. It has an onboard storage system so you can carry tools with ease.

Our biggest surprise while running the best table saw review tests was in the cutting power and the quality of cut: There wasn’t much difference among them. All these saws ripped through 3-in.-thick oak without hesitating. We tried this test with the stock blades that came on the saws. Then we repeated the test using a top-quality blade in each saw.
The more table size you have, the more support you have which is always a plus, not only for convenience but safety too. There are right side extensions that can be purchased for table saws that increase the table saw’s capacity to get to the center of a 4 x 8 sheet of wood. Although most saws have a rear band that supports the wood as it exits the saw, an additional safety measure is to rig up an outfeed support of some kind in addition to this rear bar. Be sure that the outfeed support you set up is ¼” lower than the table saw is.

A splitter is a piece of metal that keeps the blade from binding in whatever material you are cutting if the saw kerf starts to close up. The splitter is vertical and sits directly behind the blade. This plays a big part in preventing kickback and should be mounted on the motor assembly so it rises and falls with the saw blades movements. You can also get splitters that can be adjusted to fit the width of the kerf.

10 inch table saw blade


You will need specialty blades for cutting materials such as plywood, masonry, hardwood and metals. Other specialty blades are used for dado cuts. Most dado sets have multiple rows of teeth and chippers and they are typically much wider than traditional blades. Be sure that the model of table saw you have can accommodate the type of specialty blades you want to get so you don’t waste your money on a blade that won’t fit.

blue hawk table saw

×