Once you’ve made sure that the table saw is unplugged and there aren’t any extra materials in your workspace, you should turn your attention to the miter slot. See also related: Top 10 Miter Saws here. You’ll want to make sure that the miter (click here for sliding miter saws) slot is parallel to the blade. It is important that all measurements are precise and exact – nothing short of parallel will do. Once you’ve measured the blade and the miter slot, you’ll need to check the fencing as well.
best jobsite table saw 2018
If you’re working out of your garage, you may not have room for a full-size, standalone table saw. There are several tabletop models available that provide a smaller (and typically less expensive) alternative with the same wood-cutting capabilities. However, if you do have room for a full-size model, these are generally more versatile and powerful.
Bosch’s 4100-10 Worksite Table Saw is a sure win. Bosch never fails to impress us, and this table saw is no exception. It’s a 10 in. saw with a 25 in (right) rip capacity and a 47 degree left bevel. This Bosch table saw is powered by a 15A motor that reaches top speeds up to 3,650 RPM. Another feature we appreciate: its constant response circuits which continuously adapt the speed under load, giving you a continuous blade speed.
With a maximum cut depth of 3.125 inches and a 32.5-inch rip capacity, the 10-inch blade of this DeWalt table saw handled all the relatively light-duty board ripping I needed from it, but I also tested it against a variety of plywood and other board sizes to assess its capability. The 15-amp motor is fairly standard for this contractor or job site level of table saw, and none of the boards I threw at it caused it to bind—good news, as binding is at best annoying and at worst dangerous.
The continuous-read, tape measure–type scale is ingenious and easy to read, and Ridgid’s lifetime warranty covers it against breakage. The Ridgid saw has the most versatile miter gauge with holes and slots for mounting extensions and accessories. The designers have cleverly fashioned the stand to also serve as a left-side outfeed support for ripping plywood.